download
1. Refer to Figures 1 & 2. 2. Remove taillight and remove seat. SAFETY: DISCONNECT BATTERY PRIOR TO ALL WIRING MODIFICATIONS 3. Disconnect Right turn signal connector inside taillight. Pull wire from the underside of fender. Cut the wire approximately 2 inches from the connector, 02/16/09 save for reinstallation. Ensure the wires are loose from all retaining clips under fender. 4. Remove nut located behind fender holding the turn signal. 5. On the right side only, Remove the two torx bolts from fender strut, carefully pull and rotate fender strut cover to remove. Pull turn signal wire completely out. Remove bolt holding turn signal to the fender strut cover. SADDLEBAG INSTALLATION 6. Reinstall the fender strut cover using the 1 7/8″ Hex Spool Bolt Assembly and 1/8″ x 5/16″ Aluminum Spacer in the front hole and the 1 1/2″ Hex Spool Bolt Assembly and 1/8″ x 5/16″ Aluminum Spacer in the rear hole. Refer to view “B”. Insert the chrome caps into the existing turn signal holes. Bend tabs over to ensure a snug fit. 7. Repeat disassembly and installation on opposite side. TURN SIGNAL RELOCATION 8. Install turn signal bracket between license plate and license plate bracket with ears of bracket facing the front of the motorcycle, using 1/4 – 20 x 3/4 Hex cap screws, 1/4 flat washers, and 1/4 – 20 locknuts. 9. Mount turn signals directly to bracket using 5/16 – 18 x 3/4 hex cap screws with a Black Plastic Spacer, and 5/16 star washer. For a clean installation slide rubber grommet over the wire and secure into hole in turn signal, remove top center mounting bolt on license plate bracket and run wires through this hole. Splice the connector back on the wire, and reconnect to wire harness. Ensure all wires are secure under fender. Reinstall taillight. 10. Connect battery and test turn signals for function. Information: Bags will be easier to mount and remove if a small amount of silicone lubrication is applied to rubber mounting points. 11. Mount saddlebags over spools on fender strut and secure with clips retained inside bags. 12. Inspect each clip to verify each clip is properly seated in retaining groove. See View “A”
